was founded in 1955
They are a plastic molding manufacturer that performs injection molding and blow molding
Factory of Iwasaki Co
A structural issue when molding inner plugs is the occurrence of bubbles (void) in the thick wall parts
they tried to eliminate the bubbles by increasing the injection pressure
we searched for the minimum value of mold clamping force while confirming the mold clamping force waveform and actual value of the peak mold clamping force
카지노 꽁 머니orce allows for better gas escape
but they are also promoting its use with other mold and are seeing the benefits
Molding scene
From left: Mr
카지노 꽁 머니orce function (MCM) allowed the mold clamping force to be reduced to about half of the conventional force
not only does it take time to confirm whether the previous molded product is problem-free
몰드 제품
the use of the low injection pressure function (FFC) has made it possible to fill without slowing down the speed
| Products | Cycle time reduction rate |
| Inner plug A | 14.8 % |
| Inner plug B | 13.4 % |
| Inner plug C | 12.9 % |
| Stationary part A | 18.0 % |
| Cap A | 4.0 % |
the dimensions of the molded products were adjusted by applying heat using a dryer
카지노 꽁 머니uot;Molding can be performed under reasonable molding processes